联系电话

The current position:home > product > Waste gas treatment > Exhaust absorber

Exhaust absorber


Exhaust absorber



   ( It can install our patent “finned graphite modified PP heatexchanger ( the heat exchanging area is not limited)”, it can lower down thecirculation liquid temperature, upgrade the absorption efficiency, increase thefinal product density). The design is original, if there is the same, it isplagiarized.

   We provide technology service for many domestic chemicalindustry companies. No matter you have the cooperation intent or not, welcomeyou to call us to consult, we will pour outall we know without reservation”.


Brief introduction

   The device adopts the film falling absorber,filling absorber, water jet vacuum unit, storage tank and acid pump as the maindevice with the application of the advanced reverse absorption technology,which is mainly to absorb the HCL gas to prepare hydrochloric acid, as well asSO2NH3P2O5H2S etc forthe recovery and treatment. The device integrates the absorption, cooling andacid preparation.All the process can be worked under the airproof orsubatmospheric pressure, and it safe without leakage. The system adopts thecirculation absorption method, the absorption rate can reach 98%-100%, theconcentration is up to 30% or above( it is much better with the freezing saltedwater), and it is the initial product to absorb the exhaust and treat the wastegas in the chemical industry production.

The characteristics

Systematic design, packing supply, theassistance to install and debug

Full recovery, standard discharge, obvious andeffective benefit

Convenient operation, stable performance, suitingto various systems

型号及技术参数
     

注:设备配置因回收浓度和环保排放要求而增减或改变规格。

Application range

Somedifference you should know

I.         Qualification

and are authorized. The enterprises without thecertificate are not allowed to manufacture the relative products and thepurchase users will also take a risk on it.

II.      Design capability

With 25 yearsof the safety production experience, we can guarantee the design of each devicein compliance with the industrial standard, even exceed it, and it is proved tobe safe after the practical use.

Meanwhile, weprovide the technology support of exhaust absorption for many domesticenvironmental protection institutes.

III.    Materials selection

The products are certainly worth it and thesafety is the utmost.

IV.    The processing technology

When most of the similar manufacturers relied onthe manual welding processing device, we adopted to combine different weldingtechnologies like German hot melted butt-joint welding and extruding weldingetc. The welding strength was improved. Meanwhile, it put an end to thedisorder emotion and empiricism influence onthe device quality.




The factory real map
  • Factory gate real
  • Plant area real
Product drawing
  • Be fully equipped for
  • Safety point of view
  • The national marketing
The warehouse is shown in Figure
  • Rich warehouse
  • Stock
  • Stock
  • Semi finished products unit water tank
Product verification
  • The factory inspection
  • Custom(LargeLCSP-2*600-300-600The roots of water jet vacuum unit)
Propaganda
  • Exhibition publicity
  • Exhibition publicity
To share:

[点击关闭]
qq客服在线客服